E-Learning Space

In this module, the fundamentals of the materials applied in the lining processes with continuous pipes are presented and discussed.

Publisher: Prof. Dr.-Ing. Stein & Partner GmbH / 2006

Published: Prof. Dr.-Ing. Stein & Partner GmbH (2009)

The lecture describes the two different method variants, deformation process and reduction process, as well as their areas and limits of application.

This module deals with the basic principles of lining with continuous pipe processes, as well as their terminological definitions, limiting conditions, and areas of application.

Publisher: Prof. Dr.-Ing. Stein & Partner GmbH (2006)

This module introduces the method variants of lining with continuous pipes with annular space.

Publisher: Prof. Dr.-Ing. Stein & Partner GmbH (2006)

This module introduces the method variants of lining with continuous pipes without annular space (close-fit).

Publisher: Prof. Dr.-Ing. Stein & Partner GmbH (2006)

This module deals with branch connections during lining with continuous pipe.

Publisher: Prof. Dr.-Ing. Stein & Partner GmbH (2006)

This module deals with the quality assurance of lining with continuous pipes, both with and without annular space.

Publisher: Prof. Dr.-Ing. Stein & Partner GmbH (2006)

This module focuses on the theoretical background and the practical conditions to be observed on the subject of welding of polyethylene pipes for gas, water and wastewater pipelines. A further focus is on the requirements to be considered in quality assurance and in particular the consequences of non-compliance.

Publisher: Prof. Dr.-Ing. Stein & Partner GmbH / 2006

This module focuses on the parameters that must be considered when pulling in the pipe string for gas, water and wastewater pipelines. In addition to a basic description of the replacement procedure, the importance of tensile forces, bending radii and the dimensioning of the excavation pit is therefore the focus of attention.

Publisher: Prof. Dr.-Ing. Stein & Partner GmbH